Page 19 - iSEMconCatalog
P. 19
iSEMcon offers a large variety of accessories iSEMcon offers both an impedance symmetric
for the iSEMic series microphone such as Phantom Power adapter containing a special
cables, adapters and holders. circuitry to match the iSEMic microphone to
Phantom Power devices. The advantage of the
Please visit our shop pages for further informa- full featured adapter is, that the mic draws po-
tion or contact your local dealer or sales rep. wer from the hot and the cold XLR input which
makes it impedance symmetrical. The electro-
nics also limits the power draw from both, the
hot and the cold input (2mA each).
While using the full featured adapter there is an
about 1dB frequency roll-off at 10Hz.
iSEMic 725TR with SA-XBF adapter in holding
clamp.
CX-P48/BF cable use
The bushing can be used together with the hol- The microphone can also be used with a
ding clamp or shockmount to attach the mic- cost effective passive cable to be powe-
rophone to a regular microphone desk or floor red from Phantom Power. This is an
stand. It is best not to clamp the microphone asymmtrical solution and should be used for
body but the SMB connector to avoid scrat- short distances only. The power draw is not
ches or deformations on the microphone body. limited by the cable but Phantom Power Circu-
Attach the entension cable to the microphone itry (resistors) only (preamo or computer inter-
and insert the microphone into the clamp. Use face). The cold XLR input is shortened to
the Allen-key to fasten the screw slightly. ground.
DO NOT !!!
The iSEMic microphone should not be
plugged or unplugged into a mixer con-
sole or PA system unless the input chan-
nel is muted. If the system does not have a
muting option the volume should be turned off.
This avoids loud popping noise that can cause
damage in speakers and/or affect your hearing.
www.iSEMcon.com Page 19